Michael Hohl Remanufactured Subaru Brake CalipersMichael Hohl Remanufactured Subaru Short BlocksMichael Hohl Remanufactured Subaru Automatic TransmissionsMichael Hohl Remanufactured Subaru Axle ShaftsMichael Hohl Remanufactured Subaru StartersMichael Hohl Remanufactured Subaru Alternators

Genuine Subaru Remanufactured Alternators

Looking to replace your Subaru's alternator? Then be sure to visit the Parts Department at Michael Hohl Subaru where we carry a great selection of Genuine Subaru Remanufactured Alternators to get your Subaru running like-new again. It's important to use Genuine Subaru Remanufactured Parts to ensure reliability and quality.

Your Subaru's alternator is often subjected to severe temperature extremes, dust, and stress. To restore an alternator to like-new condition it requires a total disassembly and a complete cleaning. All the major components are then thoroughly tested to ensure proper operation.

Any parts that are found to be out of the specifications of the OEM are replaced with new parts. A number of the external parts are replaced to provide maximum resistance to corrosion. When the reassembly of the remanufactured alternator is complete it is then tested to ensure it passes the thorough output power and "load" tests.

Front Housing

Cleaned, inspected and retapped to Subaru specifications; replaced with new Genuine Subaru component as needed to return dimensional part to OEM specifications. (Properly installed housings with the drain hole correctly located allow moisture drainage.)

Armature

Continuity performance tested; replaced with new Genuine Subaru component as needed to meet OEM Subaru specifications.

Pulley

Checked for damage and refinished or replaced as required

Bearings

Replaced 100% with new Genuine Subaru front and rear bearings for long-life operation like a new unit.

Stator

    

600 volt performance tested; replaced with new Genuine Subaru component as needed to confirm insulation integrity and help ensure that unit performs to Subaru specification.

Terminals and Insulators

Replaced 100% with new Genuine Subaru components to provide proper conductivity and insulation where needed to help prevent unit failure.

Commutator

Remachined to average 8 micron runout - maximum 20 micron. Avoids brush bounce and helps to provide consistent voltage output to ensure unit meets Subaru OEM specifications.

Voltage Regulator

Replaced 100% with new Genuine Subaru component to provide long-life by meeting the latest OEM specifications.

Rectifier / Diodes

300 volt performance tested to Subaru specifications; replaced with new Genuine Subaru components to help ensure long-life by meeting the latest, most efficient OEM specifications.

Rear Housing

Refinished to Subaru specifications; replaced with new Genuine Subaru components as needed to provide necessary insulation and corrosion protection.

Brushes, Springs and Brush Holder

Replaced 100% with new Genuine Subaru components as brushes are a wear item and spring replacement helps prevent brush bounce which could lead to rapid wear.

Hardware

New or zinc/yellow chromate plated to provide necessary corrosion protection and superior finish appearance.
remanufactured subaru alternator